9
Factory Reset Switch
CAUTION: When using the
Factory Reset
, you will lose any settings you have saved.
To reset the unit, you will need a straightened paperclip:
1. Turn the DVR off.
2. Turn it on again.
3. While the DVR is initializing, the front panel LEDs will blink. When the front panel LEDs blink, poke
the straightened paperclip into the unlabeled hole to the left of the HDMI connector.
4. Hold the switch until the DVR’s internal buzzer sounds twice.
5. Release the reset switch. All of the DVR’s settings are now at the original settings it had when it left the factory.
Video Out
An
HDMI
(High-Definition Multimedia Interface) connector is provided so that you can use an HDMI monitor
as your main monitor.
A
VGA
connector is provided so that you can use a standard, multi-sync computer monitor as your main monitor.
Use the cable supplied with your monitor to connect it to the DVR.
Connect the spot monitor to the
SPOT
connector as needed.
Network Port
CAUTION:
The network connector is not designed to be connected directly with cable or
wire intended for outdoor use.
Power Cord Connector
WARNING: ROUTE POWER CORDS SO THAT THEY ARE NOT A TRIPPING HAZARD.
MAKE CERTAIN THE POWER CORD WILL NOT BE PINCHED OR ABRADED BY
FURNITURE. DO NOT INSTALL POWER CORDS UNDER RUGS OR CARPET.
THE POWER CORD HAS A GROUNDING PIN. IF YOUR POWER OUTLET DOES
NOT HAVE A GROUNDING PIN RECEPTACLE, DO NOT MODIFY THE PLUG.
DO NOT OVERLOAD THE CIRCUIT BY PLUGGING TOO MANY DEVICES IN TO
ONE CIRCUIT.
The DVR has a
Factory Reset
switch to the left of the HDMI connector on the rear panel.
This switch will only be used on the rare occasions that you want to return all the settings to
the original factory settings.
NOTE: Connect the monitor before the DVR boots so that video can be displayed
on the monitor with the resolution you have set during system setup. If you
want to use both the HDMI and VGA Monitor connectors, one of the monitors
should be connected before the DVR boots, and the other monitor should be
connected after the DVR boots.
The DVR can be networked using the 10Mb/100Mb/1Gb Ethernet connector. Connect a Cat5
cable with an RJ-45 jack to the DVR connector. The DVR can be networked with a computer for
remote monitoring, searching, configuration and software upgrades.
Connect the AC power cord to the DVR and then to a wall outlet.
