Revo R322, Оригинальное руководство пользователя

Страница: 16 / 28

16
R322 DRILL - W18XC473 - Revised 231111
SAFETY GUARD carry the power
CLAMPING - MAGNET CONTROL
An electro-magnet is used for clamping the tool onto the
workpiece.
The magnet is controlled by the magnet switch (F) located
at the bottom of the control panel.
„O‟ indicates magnet OFF „I‟ indicates magnet ON.
Ensure the magnet switch is OFF before connecting the
power supply.
Ensure the magnet is clean and free from debris and that
the machine is on a flat clean ferrous surface of the
required minimum thickness (10mm).
To switch the magnet ON, press the switch to the „I‟
position, the switch will illuminate to indicate there is a
power supply to the machine.
The security of the magnet should always be physically
checked BEFORE starting the drill unit.
The magnet is protected by a 20mm 2A fast acting fuse (G).
FIXING
SCREW
SAFETY
GUARD
A safety guard is supplied with this power
tool, it should be attached BEFORE using the
power tool.
The guard is attached at 1 point, by a button
head screw to the motor. The nylon washer
should be closest to the guard with the spring
washer between the nylon washer and the
screw head.
The screw should be tightened just enough to
allow the spring washers to hold the guard
up.
The guard has approximately 50mm of travel
which is adequate standard length cutters.
The guard should be adjusted so it is able to
slide with light pressure.
F
G
MOTOR