15
R322 DRILL - W18XC473 - Revised 231111
FITTING THE DRILL CHUCK SUPPLIED
To replace the arbor (A) with the drill chuck
supplied first remove the arbor.
To do this, using the spanners supplied, place
one spanner on the flats of the drill output
shaft.
Turn clockwise (as viewed from above) until
the spanner meets the dovetail slide.
Place the the second spanner on the flats of
the arbor, apply pressure, again clockwise as
viewed from above.
If possible the magnet can be used to hold
the machine whilst removing the arbor.
If the arbor is tight the spanner on the arbor
flats can be tapped with a soft mallet.
Once the arbor is unscrewed the arbor
support bracket (B) needs to be removed.
This is accomplished by removing the two
hexagon socket head cap screws.
To fit the drill chuck simply screw it into place
on the spindle nose.
A special left handed screw is provided to
hold the chuck.
Replacement of the arbor is a reversal of the
procedure above.
TO REMOVE ARBOR
A
B
USING TWIST DRILLS
Twist drills can be used with the R322
DRILL.
To accommodate twist drills, or any plain
shank cutting tool, the R322 DRILL is
supplied as standard with a 13mm drill chuck
and key.
The drill chuck takes standard parallel shank
twist drills of up to 1.5 - 13mm.
Содержание R322
Страница 23: ...23 R322 DRILL W18XC473 Revised 231111 R322 DRILL WIRING DIAGRAMS...
Страница 26: ...26 R322 DRILL W18XC473 Revised 231111...
Страница 27: ...27 R322 DRILL W18XC473 Revised 231111...