Aircraft and remote control
Controller
English
6
AIRCRAFT
ON/OFF switch
Charging port
Upper
main wing
Lower
main wing
Pilot fi gure
Aircraft b electronics
Propellers
Wings
Antenna
Insert Batteries
Charging the aircraft battery:
Rudder (left/right)
Power LED
Throttle stick (motor throttle),
climb, descent
On/off switch
Battery charger socket
4.
Replace the battery holder in
the compartment.
3.
Insert eight 1.5 V AA batteries
according to the polarity in the
battery compartment.
2.
Remove the battery holder.
1.
Unscrew and remove the cover
as shown.
Note:
Before recharging and after every fl ight, always wait 10 to 15 minutes for the battery to cool down in order to avoid damage.
Although charging is electronically monitored, it should not be left unattended.
pic. 1
1.
Turn off the aircraft and remote control.
2.
Carefully insert the charging cable plug in
the aircraft’s charging socket (pic. 1). The plug
must ease into the charging socket – DO NOT
USE FORCE. Inserting the plug incorrectly in the
socket can damage the aircraft and may cause
risk of injury.
3.
Move the control switch on the remote control
down to Charge (pic. 2). Also set the switch on the
underside of the aircraft to CHG for charging (pic. 3).
4.
The charging status LED lights up in green to show
that the battery is being charged (pic. 4).
5.
Charging is fi nished when the green LED
is no longer lit.
6.
After charging, set the Power switch to OFF and
disconnect the charging cable from the aircraft.
The aircraft can fl y for about 6 minutes when it has
been charged for 30 minutes.
pic. 4
pic. 2
5.
Close the battery
compartment cover
and screw in place.
Battery indicator LED
Trim control button left/right
Start/control LED Display
pic. 3
Anleitung_Flyer1903_GESAMT03.indd 6
Anleitung_Flyer1903_GESAMT03.indd 6
12.06.2009 14:17:44 Uhr
12.06.2009 14:17:44 Uhr
