Retrofire RF24BN, Инструкция по установке и эксплуатации

Страница: 11 / 24

11
Connect Liner to the Firebox
The vent plate will ultimately locate approximately 19”
above the base of the
fi replace once inserted.
Trim the liner accordingly so it will not be too long
once the
fi rebox in raised.
Connect the liner to the vent plate using the gear
clamp provided.
Stretch the liner down and slide the
fi rebox onto
the vent plate.
Secure the vent plate to the
fi rebox using 2 screws
through the front tab.
NOTE : When installing into larger fi replaces, the
RF24 may be connected to the liner while sitting out
on the hearth or inside the
fi replace without removing
the vent plate.
The support legs may also be left in place if the
fi replace is large enough.
If the liner is connected to the fi rebox on the hearth, it
will be necessary to pull the slack liner up from the top
of the chimney after the
fi rebox is installed.
1.
2.
3.
4.
Thread thumbscrews
into Support Leg.
Raise left hand side of firebox
and slip LH Support Leg
Under. Fasten with 2 bolts
as indicated.
Thread thumbscrews
into Support Leg.
Raise right side of firebox
and slip RH Support Leg
Under. Fasten with 2 bolts
as indicated.
Reinstall Support Legs
With the fi rebox recessed behind the smoke curtain of the existing fi replace, raise it and place the individual
support legs under it; the liner will need to compress to do this. Placing a temporary shim under the fi rebox, such
as a 2” x 4”, may help while positioning the support legs. Tabs are provided on the support legs to help position
them. Fasten the support legs at the points indicated by the arrows using the bolts provided (2 per side).
Slide Firebox onto
Vent Plate
Secure Vent Plate
using 2 screws at
Front
Firebox with Legs and
Burner Removed
Approx. 19”
above base
of fireplace
Vent Plate
Trim Liner and Connect
Vent Plate to Liner using
Gear Clamp provided
Firebox Installation