Respironics Trilogy 02, Техническая информация, Страница: 110 / 424

P
AGE
6-29
T
RILOGY
S
ERVICE
& T
ECHNICAL
I
NFORMATION
1002735, V
ER
. 05
6.7 T
RILOGY
E
RROR
C
ODES AND
C
ORRECTIVE
A
CTIONS
6.7.1 V
ENTILATOR
I
NOPERATIVE
A
LARM
E
RROR
C
ODES
NOTE
Use the corrective action(s) listed in section 6.5 (Troubleshooting Table) before using corrective
action(s) listed in the error code charts below.
ERROR
CODE
PROBABLE CAUSE CORRECTIVE ACTION
E-9 •
Motor Capacitor not installed
•
Motor Connector not soldered properly
•
Motor Rotor Locked or other mechanical
problem
•
Check the Capacitor
•
Check Motor connector
•
Replace Motor
•
Replace System/CPU PCA
E-14
•
Board revision resistors are not installed
•
Software is running on wrong revision of
the board
•
Load Correct Software
•
Replace System/CPU PCA
E-21 •
Problem with serial communication
between DSP and Host
•
Replace System/CPU PCA
E-37 •
Host CPU is constantly rebooting
•
Reinstall Software
•
Replace System/CPU PCA
E-71
•
Parameter Settings corrupted
•
Replace System/CPU PCA
E-73
•
Parameter Settings corrupted
•
Replace System/CPU PCA
E-76
•
Defective EEPROM
•
Replace System/CPU PCA
E-77
•
Defective EEPROM
•
Program Execution Error
•
Replace System/CPU PCA
E-90 •
Software does not support newer/older
revision of Hardware
•
Board revision resistors on System/CPU
PCA are setup incorrect
•
Reinstall software
•
Replace the System/CPU PCA
E-101
•
Program Execution Error
•
Contact Respironics Product Support
E-103
•
Control Flow Sensor out of electrical spec
•
Check Tubing
•
Check Manifold
•
Replace Sensor PCA