E-16
OPERATION
CHAPTER 5
1
. POWER Button
The unit will start operating when the POWER button is pressed.
Pressing the button again will stop operation.
2
. SPEED Button
The fan speed can be switched among Low, Medium and High settings.
3
. TIMER Button
The set time switches every time when the button is pressed as shown
below:
L ------ M ------ H ----- AUTO----- L...
4
. UV LAMP Button
When pressed, turn off the UV lamp.
5
. NEG.ION Button
When pressed, the generation of ions will cease and the negative ion
generator light on the control panel will go out.
6
. AUTO Button
In Auto mode, the fan speed is automatically switched
(L and M)
depending on the amount of pollution in the air.
7
. NIGHT Button
When pressed, all the indicators will go out except the POWER button
light on the control panel.
Remote Control Operation
1
2
4
6
3
8
5
7
8
. RESET Button
After the replacement of activated carbon filter
or the UV lamp, make sure to press RESET
button 3 times to reset the timer. After cleaning
the electronic cell, press the RESET button 3
times to reset the cell cleaning time.
Note
: Before pressing the RESET button, be
sure the unit is plugged in.
+
Remote Control Operation
The battery is already set in the remote control, pull out the clear sheet
from the battery cover before using.
Pull out the clear sheet
from the battery cover
before using.
Battery Information
• Open the cover on the rear
of the remote control
towards the arrow.
• Replace the battery with
CR2025 battery. Be sure to
set the battery with the (+)
side up.
• Close the cover to its
original position.
• The battery for this remote
control is for initial use only.
Change the battery when
necessary.
• When not using the unit or
remote control for an
extended period, remove the
battery.
CR2025 Battery
