Reson SeaBat 7125 SV2, Руководство оператора

Страница: 24 / 212

SAFETY PRECAUTIONS
SeaBat 7125 SV2 Operator‟s Manual
Page 8 July 25, 2011
Version 3
The following recommendations are made to protect the arrays while in use and in
storage.
For cleaning, use a mild, nonabrasive soap, fresh lukewarm water, and a soft
brush.
Rinse the sonar with fresh water after every use.
Do not clean the array or sonar by using hot or cold pressure washers. The
high-velocity water spray will cut through the polyurethane or damage the
interface between the polyurethane and the sonar metal housing.
To scrape away marine growth from the arrays, use only a wooden tool.
Do not apply any antifouling paint on the acoustic window unless the type is
recommended by RESON. The antifouling paint will affect the acoustic
performance. RESON recommends:
o
For high-frequency transducers (>100kHz) use International VC 17m.
o
For low-frequency transducers (<100kHz) use SigmaGlide.
NOTE
As these products are subject to technical modifications, it is
recommended that the most up to date PDS
3
and MSDS
4
are
acquired prior to commencing the coating work.
2.2.2.2 Wet-End Connectors
Use the wet connector maintenance kit delivered with your system (see Table 5: SeaBat
7125 SV2 Components ) to protect the wet-end connectors.
The following guidelines are recommended:
Lubricate mating surfaces with a silicone oil or equivalent (silicone oil based).
Connectors must be lubricated on a regular basis.
DO NOT grease mating surface.
Avoid nicks and cuts around contacts as these are the sealing surfaces.
Elastomers can be seriously degraded if exposed to direct sunlight or high
ozone levels for extended periods of time.
Do not overtighten bulkhead nuts.
Grip main body of connector during mating or unmating. Do not pull on cable
to disconnect.
Avoid sharp bends at cable entry to connector.
3
Product Data Sheet
4
Material Safety Data Sheet