REF-176
10
•
Insert the two-prong remote interlock connector into the back of the control box. (Figure
3:E).
•
Plug the high voltage cable from the laser into the back of the control box. Confirm that
the plug is well seated (Figure 3:D).
•
Connect the control cable from the back of the control box into the rear bezel of the laser
head by aligning red dot on cable connector to laser rear bezel receptacle and push to
insert; a mechanical click will indicate that it is properly seated.
Note: when removing
control cable make sure to pull the knurled portion backwards in order to release locking
mechanism and keep it pulled back while removing (See Figure 5). Damage can occur to
cable and/or control box if not removed properly
.
•
Insert the key into the front panel of the control box (Figure 3:C).
•
Confirm that all connections between the laser and control box are well seated and/or
locked.
•
Plug the power cord into an electrical outlet that is confirmed operational.
•
Open the beam shutter located on the laser head at the output of the laser (indicated by
the arrow on the aperture label).
Figure 6: Two Position Shutter Adjustment
•
Apply power by switching the key to the “
ON
” (vertical) position. The green emission
indicator will glow at the top of the key switch indicating power to the control box (Figure
3:C).
•
Determine which mode the laser will be operating in and move the switch on the left front
panel to Frequency or Intensity Stability mode (Figure 3:A). A yellow LED will indicate mode
of operation.
