Renova Turborex TS 180, Руководство по эксплуатации

Страница: 15 / 36

15
maintenance instructions
Our TX / TX HD brakes require periodic maintenance as they have parts subject to wear. In order to avoid problems on
the brake and to corrupt its operation, below you will find the checks to be carried out on our brakes and the
replacement procedures if something should be changed.
MAINTENANCE
• Check when the systems are switched on or in any case on a daily basis that the suction
and pressure fans are working correctly. Operation of the brake without sufficient
ventilation can lead to excessive overheating which seriously damages brake linings, fans
and other components.
• Check the wear indicator on the side casing every month. If the
indicator is positioned in the yellow area, check the state of the
linings and if some are more worn than others, swap their position. If the indicator is
positioned in the red area it is necessary to replace them.
• Check every 3 months that the pistons are not full of dust or
dirt. Clean the sliding surface with compressed air. Check that the
pistons slide freely. If not, spread a thin film of lubricating, water-
repellent, anti-adhesive silicone grease specific for metal-rubber,
the internal surfaces of the cylinder and the guide. Also check the
good condition of the lip seals. If not, replace them
• Check every 3 months that there are no lumps of dirt between the toothing of the hub
and the discs that could obstruct their free sliding. If not, clean them with a wire brush.
ATTENTION:
Before working on the brake, always disconnect the power supply to the fans. The moving
blades can be dangerous for the operator's fingers.