Renova Turborex TS 180, Руководство по эксплуатации

Страница: 16 / 36

16
spare kit (replacements)
REPLACEMENT OF THE FERRODIC PLATE
•
Remove the power supply to the fans because the moving blades can be dangerous for the operator’s
fingers.
• Remove the pneumatic power supply.
• Open the brake and remove the old brake pads.
• Check that the 4 shoe-holder plates do not show any lesions that could affect the sliding of the brake
lining discs. If necessary, replace the guides
• Fit the new plates on the brake according to the assembly instructions described above (ref. Pag. 10/11)
REPLACEMENT OF THE CENTRAL DISCS
• Remove the power supply to the fans because the moving blades can be dangerous for the operator’s
fingers.
• Remove the air supply.
• Open the brake and remove the old central discs.
• Check that the hub toothing does not show any cracks that could affect the free sliding of the discs. If
necessary, replace the hub. If there is dirt, clean with a wire brush
• Fit the new plates on the brake according to the assembly instructions described above (ref. Pag. 10/11)
REPLACEMENT OF THE FANS
• Remove the power supply to the fans because the
moving blades can be dangerous for the operator’s
fingers.
• Remove the pneumatic power supply.
• Disassemble the carter of the fan to be replaced and
then the fan taking note of the direction of assembly
that characterizes the function of air suction or
compression.
• Disconnect the plug located on the side of the fan.
• Mount the new fan on the carter and connect it to the flying socket.
• Secure the carter with the screws on the brake body.
• Power up the fan and check that it is working properly
Note: some types of fans do not have a flying socket that cuts the connection wire. In this case, removing the fan,
remove the wire up to the electrical connector and then reinsert that of the new fan. It is then necessary to reconnect
the wire to the connector with locking