Renova Turborex TS 180, Руководство по эксплуатации

Страница: 10 / 36

10
assembly procedures
Hub mounting on the machine shoulder
Check that the mounting dimensions on the frame and on the shaft correspond to those
of the brake.

Check that there is no grease or oil from faulty shaft bearing seals.

Fit the hub up to the support surface of the brake body.

Axially block the hub with a screw threaded ring nut or Seeger or screw/washer
in the shaft head.
ATTENTION:
A badly locked hub can slide on the shaft and by rotating damage the
pistons with consequent detachment of fragments that are thrown.
Brake mounting:
• Open the brake by unscrewing the 8 screws on the cover and remove the discs
and springs.
• Fit the brake body centering it on its seat and positioning the fans horizontally
to prevent them sucking dirt from the floor
• Secure it firmly with screws with tightening torque suitable for aluminum alloys
(M8>15Nm, M10>20Nm).
• Insert the first single shoe holder plate onto the guides with the pads facing the operator.
• Mount the first set of 4 springs on the guides, the central disc, the double shoe holder disc.
• Continue with the other springs, central discs and staple holder plates in sequence, then mount the last single staple
holder disc with the pads facing inside of the brake