Renova isomatic, Руководство пользователя

Страница: 17 / 28

17
Value Signal (24Vdc)
0 Inactive
1 Emergency (rapid braking)
2 Free brake (brake at zero)
3 Selection Auto/Man (enable automatic)
Range: 0000 … 3333
Default: 0000
OUT – Selection of output signals
Usage: Allow to select output signals.
Description: This parameter selects the output signal applied to outputs Do2-Do1. This value is made of 3
figures, each figure specifies the output signal of the respective pin in connector CN102.
Value Signal (24Vdc)
0 Inactive
1 Active
2 Alarm Out
Range: 00 … 22
Default: 02
ADR – Address
Usage: RS-485 serial line address.
Description: This parameter sets the address of the tension system to communicate with a serial device.
Different addresses permit to install many devices on the same line.
Note: Protected parameter, press Esc during the start up screen to enable the changes.
Range: 0...31
Default: 0
INI – Initial screen
Usage: Set the screen to be displayed at power up.
Description: Define the screen displayed at system power up.
Note: Protected parameter for remote function (INI = 9), press Esc during the start up screen to
enable the changes.
Range: 0 … 9
0 = Main menu
1 = Program
4 = Setup
7 = Stop mode
8 = Automatic mode