Renova isomatic, Руководство пользователя

Страница: 16 / 28

16
DXH –Diameter X-Hi
Usage: The operator MUST NOT change the value of this parameter (this parameter is set by the logic
part after a high calibration procedure of diameter sensor of coil).
Description:
Range: 0 … 2047
Default: 2047
DYH –Diameter Y-Hi
Usage: The operator MUST NOT change the value of this parameter (this parameter is set by the logic
part after a high calibration procedure of diameter sensor of coil).
Description:
Range: 0,0 … 3,999
Default: 1,000
ALR – Alarm level
Usage: Maximum level of tension tolerated
Description: This parameter allows to set a maximum level measurable beyond which the system will enter
the alarm mode.
Range: 0 … 199,9
Default: 199,9
DIS – Average display
Usage: Displays the average of the display.
Description: This parameter makes the average of the indication noted on the display
Range: 0..8
Default: 4
DIG – Digits number
Usage: Change the position of comma within the tension display digits
Description: This parameter allows to move the position of comma to calibrate the load cell with any unit of
measurement of weight.
Range: 0..3
Default: 1
INP – Selection of input signals
Usage: Allow to select input signals.
Description: This parameter selects the input signal applied to inputs Di4-Di3-Di2-Di1. This value is made of 3
figures, each figure specifies the input signal of the respective pin in the connector CN102.