7
Mobile Version Connections
All connections on the mobile version are made on the
back panel of the loudspeaker
• Analog/AES Input on male XLR connector. Analog
and AES-3 digital audio inputs share this connector.
Input selection from the control panel or in RHAON
II. Use 110 ohm digital audio cable for AES connec-
tions, this is recommended for analog connections
as well.
• Analog AES Loop Out on female XLR connector. In
Analog mode, this is a paralleled loop out. In AES
mode, it is a buffered and re-driven loop out. Use
110 ohm digital audio cable for AES connections,
this is recommended for analog connections as
well.
• Primary Ethernet/RHAON II/Dante connection on
an etherCON connection. Standard RJ45 CAT5e or
CAT6 patch cables may be used, etherCON shell is
recommended for all mobile applications.
• Secondary Ethernet/RHAON II/Dante connection on
an etherCON connection. Standard RJ45 CAT5e or
CAT6 patch cables may be used, etherCON shell is
recommended for all mobile applications. This con-
nection is normally used as a switched, “looping”
connector for connecting arrays. On Dante units it
may be used instead as a redundant, fail-over, Eth-
ernet network connection. Selection of this is done
in Dante Controller software.
• AC Mains Power on Neutrik powerCON TRUE1 Top
female connector. Input voltage 100-240 volts,
50/60 Hz., auto-switching.
• AC Mains Power Loop Out on Neutrik powerCON
TRUE1 Top male connector.
For connections to other mobile cabinets in an array, see
the array connections section on pg. 14.
