10
Array Assembly
ICLive X, ICLive XL, and ICLive LX modules are shipped indi-
vidually. Arrays of multiple cabinets are assembled using
the array hardware on the loudspeakers.
Every ICLive X series cabinet has array bars on each side
and the back. When building arrays these bars pin together
with three quick-release (QR) pins. The QR pins are teth-
ered to the cabinets with short leashes.
The same QR pins are used to attach the RHANG-ICLX
flybar and the ICLX-GSA ground stack adaptor plate. The
ICLX-GSA is used to attach ICLive X arrays to associated
Renkus-Heinz subwoofers.
To build an arrays of ICLX, ICLXL or ICLLX cabinets:
1. Remove the QR pins from the top of the bottom
cabinet in the array and allow them to hang from
their lanyards.
2. Stack the second module on top of the first, aligning
the three tabs on the top of the lower unit with the
three slots on the bottom of the upper unit.
3. Insert the three quick-release pins into the holes in
the array bars.
4. Important! Pull back on the pins to insure that
they are securely locked into place.
5. Repeat with all of the cabinets in the array.
6. The RHANG-ICLX flybar attaches in the same manner
to the top cabinet in the array. Align the tabs with the
slots and pin in place with the QR pins.
7. Important! Pull back on the pins to insure that
they are securely locked into place.
If you are building a tall array that will be flown, it may be
easiest to start with the top cabinet and install the RHANG-
ICLX flybar. Then lift the first cabinet and slide the succes-
sive cabinets into place pinning with the QR pins as the
array is built from the top down.
WARNING! Flying or suspending loudspeakers is a seri-
ous undertaking that should be done only by qualified
and experienced personnel. Check with an Architect or
Structural Engineer to verify any building attachment
points. Renkus-Heinz is not responsible for any non-
Renkus-Heinz products or for any misuse of Renkus-
Heinz products.
