During the first centimetres of printing, the distance between the heating plate and extruder can be fine-adjusted manually with
the buttons for heating plate movement (3).
It should be approx. 0.2 mm (corresponds to about twice the paper thickness of regular 80g/m² printer paper).
For this setting, observe that the extruder must not touch the heating plate since it may be damaged otherwise (loss of
warranty/guarantee).
The distance between the extruder and heating plate is set precisely with the software later (Z-compensation), but the
manual setting is sufficient for the first prints.
If no filament escapes from the extruder at first, the filament infeed button (4) must be pushed until filament escapes.
Let the printed object cool off for a few minutes after printing. When the temperature of the heating plate is below 40 °C (see dis-
play), the printed object comes free from the heating plate and you can remove it.
Removing the SD card
Push OK and select „SD-Card“ with the direction buttons.
Push OK and select „Unmount Card“ with the direction but-
tons.
Push OK again and then remove the SD card.
Push the direction button „left“ 2x to return to the main menu.
The enclosed SD card holds, among others, a printing file for an alternative filament holder (file name
“Filament_guide.gcode”, also see description enclosed with these instructions).
You can install this filament holder instead of the filament hose at the 3D-printer. For this, cut a short piece (approx. 3 cm)
from the filament hose and plug it into the filament introduction at the extruder as a centring piece.
