Turn the toothed belt at the base plate manually so that the Y-
plate moves up.
Keep turning until the alignment of the limit switch just installed
can be adjusted. The limit switch must be aligned so that it can
be actuated by the slotted screw in the Y-plate.
Caution: When making this setting, observe that the extruder
does not impact anywhere, which would damage it.
Place the line of the limit switch for the Z direction along the
bore below the X plate and secure it with two small cable ties
(99 mm).
Attach a third small cable tie (99 mm) that additionally connects
the lines to the extruder carriage at the top of the X-plate.
Connection of the X motor
Connect line 17 to the X-motor and place it downwards togeth-
er with the lines from the extruder carriage and the lines from
the limit switches for the X- and Z-directions.
Route the line strand into the device socket through the open-
ing in the rear cover and secure it with small cable ties (99 mm)
and a self-adhesive cable tie holder (arrow).
