2-14 System installation
Connecting your SP2-1 probe to your probe
interface card
Note...
Connection of the SP2-1 probe to the probe interface card is achieved
via the probe cable assembly (PL79 or PL127) supplied as part of your
RETROSCAN kit. If the probe cable assembly is too short for your
specific machine tool, extension cables may be obtained through your
nearest Renishaw company. Refer to ‘Before you begin’ at the front of
this publication for company names and addresses.
To connect your SP2-1 probe to your probe interface card, carry out the
following (see Figure 2.4):
1.
Remove the probe cable assembly (marked as PL79 or PL127) [1]
from carrying case.
2.
Remove probe cable assembly [1] from packaging.
3.
If required, move your PC to its required location adjacent the machine
tool.
4.
Where applicable, operate your machine tool to position the SP2-1
probe [2] at the furthest possible distance (within the machine tool’s
operating envelope) from your PC.
5.
Connect the bayonet locking connector [3] of the probe cable
assembly [1] to the connector on your SP2-1 probe [2] and fully lock
into position.
Continued on Page 2-14
Содержание RETROSCAN
