System installation 2-11
Preparation of the CC5 probe interface card
Prior to installing the CC5 probe interface card into your PC, it is important to
ensure all switch settings are correct for your specific application as follows
(see Figure 2.3):
Note...
If the setting of the switch marked SC3/ CC4 [1] on the probe interface
card is changed, this change will not take effect until the PC (into which
the card has been installed) is next powered up.
1.
Examine the slider of the switch marked CC4/SC3 [1] and, if required,
position to select the mode in which you wish the card to operate.
Note...
If the setting of the switch marked F/M [2] on the probe interface card is
changed, this change will take immediate effect.
2.
If you have selected SC3 mode at step 1, examine the position of the
upper switch setting of the switch marked F/M [2] and, if required,
position to select the mode in which you wish the card to operate.
Selecting the ‘F’ setting will cause the card to decode Fanuc serial
data. Selecting the ‘M’ setting will cause the card to decode Mitsubishi
serial data.
Содержание RETROSCAN
