Renishaw NCi-6, Руководство по установке

Страница: 16 / 32

2-8 NCi-6 non-contact tool setting interface: NCi-6 basics
IMPORTANT: Setting a switch
When setting a switch to either the On or Off position, apply firm pressure to make sure it is fully in position.
Switch bank SW1
Switch On Off
1 Not used On Off Not used .
2 NC set-up On Off Used when setting up an NC unit . Set this switch to On so that the
alignment voltage can be maximised . After maximising the voltage,
set the switch to Off so that the automatic gain circuitry can set the
operating voltage .
3 Drip rejection On Off When the drip rejection mode is set to On, the effects of individual
drops of coolant on measurements are filtered out.
NOTE:
For safe operation, set the spindle speed and spindle
override as described below .
4 Spindle r/min 500 1000 Used with drip rejection . For safe operation, the spindle speed must
be fixed at a whole multiple, e.g. 1000, 2000, or 3000; or 500, 1000,
or 1500, and the spindle override must be disabled .
Switch bank SW2
CAUTIONS:
With the SSR output switch(es) set to Off, i .e . normally open (N .O .), the respective output will remain in a
non-triggered state if the power supply is interrupted and/or a poor connection is made to the SSR .
If using SSR2 as an oscillating or pulsed output for a trigger signal to the control, the level output SSR1
must be used to guarantee a reliable probe status check .
Switch On Off
1 SSR1 N .C . N .O . Sets the SSR output to either normally closed (N .C .) or normally
open (N .O .) .
2 SSR2 N .C . N .O . As above .
3 SSR2
Type1 Level Pulsed Sets the SSR2 output to level or pulsed .
Refer to page 2-9 .
4 Pulse width 20 ms 100 ms Sets the pulse width to either 20 ms or 100 ms (For more
information see chapter 3, “System installation” ) .
M-code 3 may be used to invert the switch setting .
NOTE: For the cycle to work, the pulse width value selected must
be the same as the value that is configured in the tool setting
software .