Renishaw NCi-6, Руководство по установке

Страница: 14 / 32

2-6 NCi-6 non-contact tool setting interface: NCi-6 basics
Interface LEDs – status LED
LED colour Tool set mode 1 Tool set mode 2
Green/amber Flashing at 1 Hz .
The system operating voltage is too
high .
The system will continue to function,
but for optimum performance repeat
the set-up and alignment procedures .
The probe is untriggered .
Flashing at 1 Hz .
The system operating voltage is too high .
The system will continue to function, but for
optimum performance repeat the set-up and
alignment procedures .
The probe is triggered .
Green The beam is clear .
The probe is untriggered . The beam is clear .
The probe is triggered .
Amber The beam is partially blocked . *
The probe is untriggered . The beam is partially blocked . *
The probe is triggered .
Red The beam is blocked .
The probe is triggered . The beam is blocked .
The probe is untriggered .
No light No power to the unit
* If the laser beam is clear and the LED is amber, this indicates that the system will continue to function,
but for optimum performance maintenance is required .
Refer to the applicable installation and user’s guide (for NC4 , Renishaw part number H-2000-5230 or
NC4+ , Renishaw part number H-6270-8501 or NC4+ Blue , Renishaw part number H-6435-8501), for
details of the possible actions required .
LED colour
High speed broken tool
detection mode
Latch mode
Green/amber Not applicable . Flashing at 1 Hz .
The output is not latched .
The system operating voltage is too high .
The system will continue to function, but for optimum
performance repeat the set-up and alignment procedures .
Green Not applicable . The beam is clear .
The output is not latched .
Amber The output is not latched .
The beam is blocked . The output is not latched .
The beam is blocked . *
Red The output is latched .
The tool is broken . The output is latched .
No light
* If the laser beam is clear and the LED is amber, this indicates that the system will continue to function,
but for optimum performance maintenance is required .
Refer to the applicable installation and user’s guide (for NC4 , Renishaw part number H-2000-5230 or
Swi NC4+ , Renishaw part number H-6270-8501 or NC4+ Blue , Renishaw part number H-6435-8501), for
details of the possible actions required .