- 14 -
6. Cleaning / Maintenance
Inside the appliance there are no parts which require maintenance.
Opening the device, other than for the processes described below, is not permissible!
6.1 Replacing the Dust Bag
The set dust bag fill level has been reached:
♦
The dust drawer symbol (33, Fig. 2) blinks.
♦
An audible signal will be emitted 3 x.
♦
The display blinks “Cod01”.
Emptying the dust drawer:
⇒
Switch the extractor off.
⇒
Pull the front panel forward and off (5, Fig. 1).
⇒
Pull the dust drawer (7) out towards the front.
⇒
Remove the protective film from the glue flap and use it to
cover the dust bag opening!
⇒
Dispose of the dust bag properly.
⇒
Insert a new dust bag into the dust drawer. Ensure that the
new dust bag is properly aligned in the guide grooves (21)
and the glue flap faces upwards.
Use only original Renfert dust bags (see spare parts list).
⇒
Inspect the dust drawer seal for damage and replace it, as
required (24).
⇒
Insert the dust drawer, making sure it is straight, and push it in as far
as it will go. Make sure that the dust drawer is seated correctly on
the guide (23, Fig. 16).
⇒
Install the front panel (5, Fig. 1) on the bottom hooks then push it
into the upper lock bolts (22, Fig. 16), pressing firmly until it locks in
place.
6.2 Filters
The extractor contains a 2 level filter system comprising:
• dust bag
•
fine particle filter
NEVER operate the dust extractor without the complete filtration system.
Use only the original Renfert filter (see spare parts list).
Fig. 16
22
23
7
Fig. 17
21
Fig. 18
24
EN
