QB-V850MINIL, QB-V850MINI Emulator 4. Debugging with In-Circuit method
R20UT0221EJ0400 Rev.4.00
Page 62 of 86
2013.08.30
4.3
Setup Procedure
This section describes QB-V850MINIL or QB-V850MINI setup procedure to operate QB-V850MINIL or
QB-V850MINI normally. Perform setup using the following procedure.
Installation of software
Install the USB driver, software tool, etc., in the host machine.
See
4.3.1 Installation of software
.
Proceed to the next step if installation of software has already been completed.
Setting of switch
The SW1 settings vary depending on the purpose of use of the V850MINI self-check board.
At shipment, SW1 is set to perform self-testing (self-check mode).
See
4.3.4 Switch settings
for details.
Connection and startup of system
Connect the host machine, QB-V850MINIL or QB-V850MINI, V850MINI self-check board, and target system
and start the entire system. See
4.3.6 Connection and startup of system
to perform setting in the correct order.
System shutdown
Shut down the system to terminate debugging.
See
4.3.7 System shutdown
to shut down the system in the correct order.
Setting of QB-V850MINIL or QB-V850MINI
Set QB-V850MINIL or QB-V850MINI SW1 to the default setting.
See
3.3 Default Setting
for the default settings of QB-V850MINIL or QB-V850MINI.
Setting of clock
At shipment, an 8 MHz resonator (ceramic resonator) is mounted as the main clock in OSC1 on the V850MINI
self-check board.
A 32.768 kHz resonator is also mounted as the subclock. See
4.3.3 clock settings
for details.
Mounting of target connector
Mount the target connector on the target system.
See
4.3.5 Mounting of target connector
.
Proceed to the next step if the target connector is already mounted.
