REMKO RVS 100H INOX, Руководство по эксплуатации

Страница: 17 / 44

Fault indicated by code
Code Fault type Re-set Intake type Cut-off
Intake value Automatic Manual Digital Analog Compr
essors
Condenser fan Cir
culation pump
A1 Antifreeze alarm medium cycle B2 P05 OWT 13/11 x x
AHt Excess temperature at start B1 / P16 x IWT 10 x x
ALt Insufficient/or excess temperature at start C/H B1 / P19 x IWT 10 x x
CP1 Compressor 1 x x
E1 Temperature sensor medium intake defective B1 x IWT 10 x x x
E2 Temperature sensor medium output defective B2 x OWT 13/11 x x x
E3 Temperature sensor condenser defective B3 x PT 14/12 x x x
E4 Pressure tranceducer cooling cycle defective Bn/V+ x PS Bn/V+
EHS High supply voltage controller x x x x
ELS Low supply voltage controller Tr x x x x
EP1 EEPROM driver defective x x x x
EPb EEPROM fault at start Config. x x x x
EPr EEPROM fault during operation Config. x x x x
FL Flow monitor has responded ID1 x FS 6/9 x x x
Hc1 Maintenance interval compressor 1 C14 x
Ht Excessive temperature medium cycle B1 / P16 x IWT 10
HP1 Pressure switch HD cooling cycle ID3 <3/hrs <3/hrs HP 2 x on 1 min.
HP1 Tranceducer cooling cycle excess pressure Bn/V+ x PS Bn/V+ x x x
LP1 Pressure switch ND cooling cycle ID4 <3/hrs <3/hrs LP 3 x x
tC1 Overload cycle 1 P08-13 x x x
tEr Communication cabled remote control x x x x
tP General overload P08-13 x x x x
Reports
LA General reports P08 x
D1 Report defrosting x
dF1-2 Defrost cycle exceeded
Defrosting
period
x x x
Reset
1. Faults with automatic reset: The reset is carried out automatically.
2. Faults with manual reset: The reset can only be carried out by a specialist after the fault has been corrected.
3. Faults with semi-manual reset: The reset is first carried out automatically, afterwards only a manual reset is possible
by a specialist, after the fault has been corrected.
Fault Code Possible cause check Remedial measures
The unit
does not
start or
switches
itself
off.
ELS/EHS
Low/High supply voltage
controller
Initial voltage transformer, or mains
inlet voltage
Have checked by a
specialist.
EP1 EEprom controller error Does the controller operate properly?
Have specialist check regulation or
parameters.
EPr EEprom controller error Does the controller operate properly?
Have specialist check regulation or
parameters.
Malfunctions
17