REMET CNC RS-120 OFF-ROAD, Техническая и движущая документация, инструкция по эксплуатации, гарантийный талон, каталог запасных частей

Страница: 20 / 52

REMET CNC TECHNOLOGY SP. Z O.O.
Page 20 of 51
Manufacturer of machinery and equipment, machining
6.
TRANSPORTATION AND STORAGE OF THE DEVICE
The device on its own wheels should be transported on the hardened one
and not a slippery surface when the combustion engine is off, in the case of soft
and uneven ground transport the device only by means of this type of transport
on a platform that guarantees adequate stability in a vertical position.
The device should be stored out of reach of children in a dry place at 0ºC
to + 40ºC, it must not be stored in rooms with a source of fire (e.g. gas oven).
7.
MAINTENANCE AND CLEANING
Safety instructions for maintenance
The device must be disconnected from the power source and placed on a
stable, even and non-slippery surface before carrying out maintenance or
repairs. Clean the device before and after each use, and check the tightness of
the screws that secure the covers.
General activities related to maintenance and cleaning
The device should be kept clean at all times. To clean the device, use only a
brush or cloth. Never use any solvents or cleaning agents.
Check all covers and protective elements are undamaged and in the correct
place. Replace if necessary. Pay special attention to loose and worn parts. Check
for screws and the nuts are tight.
Before every use, check the gear lube condition. A graphite grease is
recommended for the lubrication of a gear transmission.