REMET CNC RS-120 OFF-ROAD, Техническая и движущая документация, инструкция по эксплуатации, гарантийный талон, каталог запасных частей

Страница: 17 / 52

REMET CNC TECHNOLOGY SP. Z O.O.
Page 17 of 51
Manufacturer of machinery and equipment, machining
12. During every break in work, the motor driving the chipper must be turned
off.
13. When the cutting system is working even for a certain period of time, it is
prohibited to transport, move or lift.
14. To avoid jams, one should alternately insert limp and thin material
with larger branches.
15. Turn the device off when the entire material has passed through the
crushing roll. Otherwise, the device may jam.
16. During operation, keep a safe distance from the device, because long
branches can be thrown out during the retraction.
Getting the machine out:
Despite the lack of working restrictions for the first start of the wood chopper,
the following checks are recommended:
Before first use and working 1 hour:
• Check tightness of all screws,
•
Check the condition of the bearings,
•
Check the condition of the cutting blades. Adjust or replace if necessary.
•
Lubricate the gear unit.
After working every next 10 hours:
•
Repeat the above steps.
Activities after finishing work.
1.
After switching off the drive, wait a short time, because the rotating parts
of the mechanism are still working for some time after the drive is switched off.
2. Make sure that the machine is able to stop completely and then perform
activities related to the cleaning and maintenance of the machine.
3. Set the machine down and secure it in the parking spot.
4. Checking the technical condition, regulating and performing temporary
repairs and maintenance works as well as cleaning of parts and working units can
be carried out only when the chipper has switched off the drive.
5. Periodically checks that all screws and nuts are tight. Damaged replace.
6. When changing the damaged chipper knife, always tighten or loosen the
knife using protective gloves and following the instructions in section 10.