REMET CNC RS-120 OFF-ROAD, Техническая и движущая документация, инструкция по эксплуатации, гарантийный талон, каталог запасных частей

Страница: 14 / 52

REMET CNC TECHNOLOGY SP. Z O.O.
Page 14 of 51
Manufacturer of machinery and equipment, machining
Saftey switch
The chipper is equipped with a safety switch, which is mounted on the
handle or on the inlet cover. Prior to each commencement of work, check the
correct operation of the safety switch, when the safety switch system is on, the
engine cannot start. If the engine starts with the safety switch pressed in, work
must not be started until the fault has been corrected by a qualified employee.
Things to do before starting work
Before starting work:
1. Inspect the chopper before each use. Check that the safety and propulsion
system functions correctly. If not, the system should be repaired before starting
the chipper.
2. Before starting work, it is necessary to make sure that all guards are properly
fastened (check tightness of screws).
3. The machine should be placed on an even, hard, non-slip surface with
extreme caution.
4. Before comminuting, make sure that there are no bystanders or animals near
the machine.
5. Before switching on the chipper's internal combustion engine, check the
tension of the V-belts.
Only in RS-120+PTO:
The safety switch must be compressed /
connected to the emergency safety switch
module on the tractor. The method of
interruption of work depends on the integral
protection systems of the tractor.
The safety switch installed at the chipper
inlet is an extension of the emergency stop /
safety systems of the tractor.
The safety switch when it is switched on has
the character of a short-circuit constant.
After removing the failure or averting the
danger in order to proceed with further work,
physically unlock the circuit breaker, "pulling
out” yellow locking button.