2
91589
INSTALLATION INSTRUCTIONS
1. Locate the dispenser indoors on a level counter top.
LEG OPTION
Unpack the four (4) legs and install them into the threaded holes provided in the bottom of the unit. Before
installing, remove the four (4) plastic thread plugs; push center in and remove plug.The installer must pro-
vide flexibility in the product and utility lines to permit shifting the position of the dispenser sufficiently to
clean the area beneath it.
COUNTER MOUNTING
The ice dispenser
must be sealed
to the counter. The template drawing indicates openings that must be
cut in the counter. Locate the desired position for the dispenser, then mark the outline dimensions on the
counter using the template drawing. Cut openings in the counter.
Apply a continuous bead of NSF
International
(NSF) listed silastic sealant (Dow 732 or equal) approximate-
ly 1/4
?
inside of the unit outline dimensions and around all openings. Then position the unit on the counter
within the outline dimensions. All excess sealant must be wiped away immediately.
2. The beverage tubes, drain line and power cord are routed through the large opening in the bottom of the
unit. See the MOUNTING TEMPLATE for locating the required clearance hole in the counter for these
utility lines.
3. SINK DRAIN ASSEMBLY: Connect the drain tube to an open drain. Additional drain tubing is provided with
the unit. The drain line must continuously pitch downward away from the unit and contain no “traps”or im-
proper drainage will result.
DRAIN LINE
STAINLESS STEEL ELBOW
DRAIN TUBING PROVIDED
WITH DISPENSER
DISPENSER BOTTOM
FIGURE 1. MOUNTING TEMPLATE
A. Use tube, clamp and insulation provided to assemble drain.
B. To assure proper drainage, do not allow “trap”to form in drain line. Be sure drain line runs flat with
bottom of dispenser. (See Figure 1)
4. Connect the beverage system product lines as indicated in the Beverage System Schematic (See Figure
6). This work should be done by a qualified service person. Note that the hoses are marked with numbers
1 through 8 for
syrup connections
and “CW”for
carbonated water connections
.
5. Clean the hopper interior (see CLEANING INSTRUCTIONS).
6. Connect the power cord to a 120 volt, 60 cycle, 3-wire grounded receptacle.
NOTE:
Water pipe connections and fixtures directly connected to a potable water supply must be
sized, installed and maintained according to federal, state and local laws.
