35
1.1.28
3.1.6
Fitting the load chain
– single fall version –
figure 11: fitting the load chain
– single fall version –
1. The hoist is prepared with a short piece of chain on the sprocket wheel.
2. The connecting piece included in delivery has to be linked with the short piece of chain always at the side of the
chain collector. The load chain has to be linked with this connecting piece too.
3. Insert the load chain by pressing the down button
4.
Remove the short piece of chain and the connecting piece.
5. Fit the single fall hook to the end of the load chain.
6. Lower the load hook to its final position
7. Attach the end* stop to the third chain link.
8. Fit the chain collector according 3.1.5.
9. Allow the chain running into the chain collector and lubricate the whole chain length well.
Caution!
When changing the load chain and converting to other numbers of falls never allow the
chain to come out of the casing completely, always pull in new chain or a short piece of
chain with the connecting piece. After having mounted the new load chain remove the
short piece of chain and connecting piece (
see section 3.1.8 !).
Let the dead end of the chain go into the chain bag by pressing the up button and using the hoist motor
to prevent knots inside the chain collector.
Hold down
Chain guide
Sprocket wheel
Short piece of chain
to support fitting the
chain
Connecting piece at
the chain bag side
Load chain
Lift limiter
Load chain
Single fall hook
Содержание LK-13 Series
