Relative workshop V3 M-Series, Руководство пользователя

Страница: 52 / 84

V E C T O R O W N E R ’ S M A N U A L
Page • 52
It may be necessary to adjust the length of
the closing loop to make the flaps align
properly. The curved pin should be held
firmly in place, but a force of no more than
12 pounds should extract it and open the
container. The standard length for the closing
loop is 1 5/8 inch, (4.1 cm) ± 1/8 inch ( ± 3
mm).
8. Double check the yellow hook and loop
fastener patches to be sure they are mated
properly. If there is not enough slack in the
bridle to allow proper mating of the hook and
loop fastener, create a small amount by
gently pulling the bridle out of the main
container.
Ensure the bridle extends from the locking
pin to the pilot chute without passing through the harness. Mate the loop fastener on the bridle to the hook fastener
on the bottom flap; you’ll have to tuck the bridle under the #2 right side flap to do this. Close the main pin cover flap
and be sure it completely covers the pin and bridle.
7. Slowly remove the pull-up cord to
prevent excess friction from damaging the
closing loop. It is best to pass the pull-up
cord under the closing pin while extracting
it. Doing so places the primary friction point
between the pull-up cord and the closing
pin, thereby reducing wear on the closing
loop.
section 4 : closing the main container
9. Tuck the excess bridle under the bottom
edge of the #2 right side flap.
Note that the
grommets do not
line up - see picture.
n
ote