Pg. 8
Doc ID: 191-7911A
Doc Rev: 080420
INSPECT THE DAMPERS
The OE dampers inside the center hub assembly shrink due to heat
and use. Any movement between the dampers will shorten the life
of your clutch. Inspect the dampers before proceeding and replace
if necessary. Use the following instructions to inspect the dampers.
1. Hold the center hub assembly in your hands, then place your
thumbs on the inner hub by the embossed part numbers.
2. Rotate the inner hub back and forth inside the outer hub.
Rekluse recommends replacing the dampers if you feel any play
between the two hubs
–
KTM part number #78132025100.
CLUTCH PACK INSTALLATION
Each clutch pack comes with a set of steel plates, a set of friction
disks, and an EXP disk.
The clutch pull effort has different pressure ring settings that
depend on the thickness of the clutch pack. You will need to
measure the clutch pack
BEFORE
you begin if you wish to optimize
the clutch pull effort vs. clutch performance. Please refer to the
Setup Sheet at the back of the manual
for clutch pack
specifications and information. Otherwise, continue with following
instructions.
