Maintaining the coupling
45
Replacing the toothed ring
Proceed as follows to disassemble the toothed ring:
Disassemble the retaining cap (2) from the hub body (3).
Loosen the bolts (1) for this purpose.
Put the bolts (1) aside for later use.
Slip the retaining cap (2) from the hub body (3) onto the shaft.
Start at the parting line of the split toothed ring and lever the toothed ring out from
the coupling claws.
Where necessary, use suitable tools for this purpose.
Retain the toothed ring (4) in a suitable container for subsequent disposal.
Proceed as follows to mount the new toothed ring (4):
Place a rubber buffer on top of a coupling claw so that its belt points to the hub
body on the opposite side. It may be necessary to place the rubber buffer on top
at an angle.
Firmly press the rubber buffer onto the coupling claw.
Where necessary, use suitable tools such as a rubber mallet.
Repeat these steps until all rubber buffers of the toothed ring are mounted.
Slip the retaining cap (2) onto the hub body (3).
Fasten the retaining cap (2) using the bolts (1).
Tighten the bolts crosswise with the necessary torque, see page 32.
Mark the bolts which have been tightened to the required torque in colour.
Содержание MMS-T W Series
