Safety information
10
2.3 Notes and requirements
The system was developed and designed by the generally accepted rules of
technology.
Nevertheless, residual dangers to the life and limb of the operator or the risk of -
damage to the system or other property may still arise in the use of the system.
Safety equipment must never be dismantled or put out of operation as this will
result in dangerous hazards and the intended use of the system is no longer
guaranteed. The dismantling of safety devices for equipping, repairing and
maintenance is described in detail. The safety devices must be refitted
immediately on completion of such work.
When using external aids and agents (for example, solvents for cleaning) the -
user of the system is responsible for ensuring the safety of the unit.
All safety instructions and warnings and the nameplate on / near the system must
be kept visible and legible.
The occupational safety and health regulations serve as safety references. They
must be observed.
The special safety instructions given in the main text must also be observed in
addition to the safety instructions given in this section.
Beside the advice given in these operating instructions, the general safety and
accident prevention regulations (in Germany, among others UVV BGV A3, TRBS
2131 and BGR 500 Chapter 2:26 (previously VGB 15) "Welding, cutting and
allied processes" and particularly the conditions for arc welding and cutting
contained therein or the corresponding national regulations) must be observed.
Also observe the safety information signs on the factory floor of the operator.
REHM welding machines are, except when this is expressly stated in
writing by REHM, only for sale to commercial / industrial users and are
only intended to be used by these.
TIGER TIG inert gas welding systems may only be used
as intended
in an absolutely perfect condition
TIGER inert gas welding equipment is designed in accordance with EN 60974-1
Arc welding equipment -
welding power sources for overvoltage category III and pollution degree 3 and in
accordance with EN 60974-10 Arc welding equipment - electromagnetic
compatibility (EMC) for Group 2 Class A and should be suitable for use in all
areas, except residential areas that are connected directly to a public low-voltage
supply system. It may possibly be difficult to ensure electromagnetic compatibility
in these areas due to both conducted and radiated interference. For this purpose
the use of appropriate measures to meet the requirements (filters for mains
connection, shields such as shielded cables, the shortest possible welding
cables, earthing of the workpiece, potential equalization) and assessment of the
environment (such as computers, controllers, radio and television broadcasters,
adjacent people, for example required in the use of cardiac pacemakers) are
required. The responsibility for any fault lies with the user. For more information
and recommendations, see, inter alia, DIN EN60974-10: 2008-09, Annex A.
Hazards of non-
compliance
Safety
instruction
Applications
Содержание TIGER 180 AC/DC ULTRA
