Rehau RE.GUARD, Руководство по эксплуатации

Страница: 7 / 11

5. Wait for the adding process to end.
6. Successful adding will be confirmed by the Z-Wave controller’s
message.
Tip:
If you want your Water Sensor to be a security device that uses
secure/encrypted message to communicate in a Z-Wave network,
then a security enabled Z-Wave controller is needed.
Z-Button
5. Wait for the end of the removing process.
6. Successful removing will be confirmed by the Z-Wave controller.
05 Resetting
Reset procedure clears the Water Sensor’s memory, including Z-Wave
network controller information and advanced configuration.
To reset a Water Sensor:
Press and hold the Z-button for more than 20 seconds until blinking ends.
Removing:
1. Open the cover.
2. Place the device within the direct range of your Z-Wave controller,
e.g. RE.HUB Gateway.
3. Set the main controller remove mode (see the controller’s manual),
e.g. via RE.GUARD App.
4. Press the Z-button briefly three times, the LED indicator should blink
fast in orange.