Regulus KPC1 BP, Инструкция по установке и эксплуатации

Страница: 9 / 29

9
2.3 Fixing rails on roof anchors
• have ready two rails in the length required for the
number and type of collectors to be installed.
• Align the travelling screw head (Fig. 10) with the hori-
zontal rail and shift the rail onto it, or shift the screws
into the rail
fi rst and fi x to the anchors. Use serrated
lock washers to fi x the nuts.
• Align the rails so that they lie in parallel to roof tiles.
The diagonal between the rails must be of the same
length: D1 = D2 (Fig. 11).
• Then tighten the nuts on fi xing bolts.
2.4 Collector mounting
Collectors shall be covered during mounting.
Installation:
• Insert safety retaining brackets (Fig. 12) into the bot-
tom rail, 2 brackets per collector.
• Insert the retaining brackets into the bottom rail about
100 mm from the collector edge.
• Lay the fi rst collector carefully on the rails and align it
in the brackets.
Collectors shall be placed on the rails with
marking upwards. The distance between the
bottom edge of the collector and of the base rail
depends on the design and size of the retaining
brackets. The collector bottom edge is by circa
75 mm lower.
• The distance between the collector edge and the end
of the bottom rail is B = 35 mm (Fig. 13)
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
rozm Ĉ r kolektoru
1000 × 2 000 mm
Installation
of 1 collector
on rectangu-
lar roofi ng
Installation of 2 collectors on rectangular roofi ng
Installation of 3 collectors on rectangular roofi ng
Installation
of 1 collector
on square
roofi ng
Installation of 3 collectors on square roofi ng Installation of 2 collectors on square roofi ng
roof anchor
top / bottom rail
M8 bolt with
travelling head
parallel
D1
D2
Fig. 10: Fixing the rail onto the roof anchors
Fig. 11: Alignment of base rails
2.2.5 Installation with universal templates for Cembrit roofs
Distribute the universal templates on the roof in such a manner that the layout of fi xing points corresponds to the Fig. 9.
Fig. 9: Layout of universal templates