Regulus KPC1 BP, Инструкция по установке и эксплуатации

Страница: 12 / 29

12
4.2 - Flat roof support mounting
A fl at roof support consist of two base rails, triangular
supports and one strut.
The number of triangular supports depends on the num-
ber of collectors. One strut is suf
fi cient for supports for
up to 5 collectors.
Installation:
• Lay two rails in parallel on the mounting surface, their
pitch shall be 1660 mm.
• The diagonals between the rails shall be of the same
length: D1 = D2 (Fig. 16)
• Insert the M8 bolt with a special head (Fig. 18) into the
rail grooves.
cca 500 mm
D2
2
4
4
1660 mm
T strut
base rails
L strut
D1
Fig. 16: Aligning the rails and mounting the fi rst triangular support
• Assemble the triangular supports that come partially
screwed together (Fig. 17). Fix the loose support ends
with a bolt (Fig. 17) and tighten all connections.
• Locate the positions to fi x triangular supports. The
distance of the fi rst triangular support from the end of
the rail shall be about 500 mm..
• Fix the L-support of the triangle to the base rail using
screws, serrated lock washers and nuts for rails (Fig.
19) and tighten the connections.
• Install the next triangular support in the same way. Its
distance is the same as that of the roof anchors in
Fig. 2.