Regency HRI4E-LP, Инструкция для владельца и по установке

Страница: 26 / 56

26
|
LRI4E / HRI4E Direct Vent Gas Insert
|
26
installation
LRI4E LOG SET INSTALLATION
919-408 07.03.14
1. Seat Log 1 on the back left side indent in the burner. When Log is
seated, grasp both ends of the Log and slide forward until Log 1 is
snug against raised portions of burner.
2. Identify corresponding pin locators on bottom of Log 2 and line up
with pins on burner- see below.
3. Seat Log 3 into indent in burner as shown below.
4. When seated, push Log 3 to the back as far as it will go within
indent. to prevent any carboning.
Read the instructions below carefully and refer to the images. If the logs are broken do not use the unit until they are replaced. Broken
logs can interfere with pilot operation.
Improper positioning of the logs may create carbon build-up and can alter the unit's performance which is not covered under warranty.
*For Touch Ups: Satin Black paint is included for burner, and Dark Brown Paint is included for log set,
1 Rear Bottom Left Log
2 Right Upright Log
3 Middle Right Log Piece
4 Front Left Log Piece
5 Front Right Log
6 Front Right Angled Log
7 Top Back Log
1
2
3
4
6
7
5
1
2
3
3
Log 3 push to the back of the indent
Log 1 location on burner
Log 2 pin locator, line up with pins on burner
1
LRI4E
LOG INSTALLATION