Regency Cascades I1500, Инструкция для владельца и по установке

Страница: 9 / 44

I1500 Regency Wood Insert
| 9
9
|
installation
920-051b
03.24.20 1
FLUE ADAPTOR INSTALLATION
Part # - 919-874
Description: Prop. 65 Short form label
Date: May 30/18
Colour: Black font on white
Size: 5"W x 0.7"H
919-874
!
WARNING
:
Cancer and Reproductive Harm
www.P65Warnings.ca.gov
6. Slide the unit back until the flue adaptor is slightly
engaged. At this point it is recommended to level
the unit. This will keep the adaptor from binding
Pull Rod
8. To complete the install, use the two bolts,
washers and lock washers (supplied in manual
pack) and install them, tighten down using the
1/2" socket to ensure the adapter is positively
secured to the unit. Once completed remove
pull rod and place away for future re-install.
Flex Liner
Pull Rod in place
Diagram 1
Diagram 2
Diagram 4
Diagram 3
Diagram 5
Diagram 6
Diagram 7
Flue Adaptor
4. Fully insert the probe into the probe bracket as
shown. See diagram 3.
INSTALLING YOUR INSERT
SAFETY NOTE: The insert is very heavy and will
require two people to move it into position. The
door and bricks can be removed to help. Be sure to
protect your hearth extension with a heavy blanket
or cardboard during the installation.
NOTE: The unit requires to purchase either the
standard or offset flue adaptor that is best suited
for the specific installation.
Flue adaptor contents:
- Flue adaptor with catalyst cartridge housing
installed
- Bypass rod
- Clip to secure the bypass rod
Flue
Adaptor
Bypass
Rod
Clip
NOTE: The catalyst and the two bolts to secure
the adaptor to the unit are packaged with the unit
in the manual package.
List of Tools required:
- Tin snips
- Pull rod (supplied with unit)
- 1/2” socket / ratchet
- 3/8” open face wrench
- 7/16” socket/ratchet
2. Install flex liner into existing chimney as per liner
manufacturer’s specifications. Ensure that the
notch on the adapter cut in the previous step is
pointed forward at about the 6 o'clock position.
See Diagram 1.
3. Secure the adaptor to the flex liner with three
screws. Ensure the adapter is level and aligned
correctly. See Diagrams 2 & 2A.
5. Install the unit by first setting the rear of the unit
into the fireplace. See Diagram 4. Ensure that
the unit is centered in the existing fireplace and
lined up with the flue adaptor.
7. Insert the provided pull rod through the hole in
the top center of the unit. Secure the threaded
end into the flue adaptor as shown in diagram
5. While sliding the unit into place pull on the
rod to ensure that the flue adaptor is properly
engaged. See Diagram 6. Double check the
adaptor is seated properly and the pull rod in
the firebox, locate the two holes lined up to the
two holes on the adaptor. After sliding adaptor
into position, make sure the flue adaptor is tight
against the body, and no light is seen coming
through between the adaptor and body of insert.
1. Cut a notch into the adaptor approximately ¾” high
by 1 “ wide as shown. This is to accommodate
the probe in the following steps.
Adaptor
Diagram 2A
Probe Bracket
Cutout in
adaptor properly
aligned to probe
bracket