Regency Cascades I1500, Инструкция для владельца и по установке

Страница: 27 / 44

I1500 Regency Wood Insert
| 27
27
|
maintenance
NOTE: Replacement combustors can be retrieved from Applied Ceramics
or Contact your local Regency Dealer. See warranty information at
the back of this manual for details.
DO NOT OPERATE THE APPLIANCE IF COMBUSTOR BECOMES
INACTIVE - DO NOT OPERATE WITHOUT COMBUSTOR.
SECONDARY AIR TUBE REMOVAL /
INSTALLATION
1. Allow the stove to burn out and cool down, until cool to touch.
2. Open stove door to access secondary air tubes.
3. Grasp secondary air tube firmly with vise grips, using a hammer tap vise
grips from right to left until air tube is released from grip. Remove.
Note: to make it easier to remove the air tubes, first remove both the bottom
right base brick and right side wall brick.
4. Remove top left and right metal retainers, followed by the fragile three
piece C-Cast Baffles (see catalyst removal instructions for details), then
remove the remaining 2 tubes.
Secondary Air
Tubes
5. To reinstall or replace, first slide left side of tube into hole on left side air
channel. Align tab on right side air channel with notch on right hand end of
air tube. Firmly grip center of air tube with vise grips, use hammer to tap vise
grips from left to right until the tube bottoms out into the air channel on right.
LATCH ADJUSTMENT
The door latch may require adjustment as the door gasket material compresses
after a few fires. Removal of the spacer washer, shown in the diagram below,
will allow the latch to be moved closer to the door frame, causing a tighter
seal. Remove and replace the nuts, washer and spacer as shown.
REMOVING WOODEN
HANDLE
1. To remove the wooden door handle from unit, firstly locate 7/64” Allen key
hole at the bottom of wooden handle.
2. Unscrew 7/64” Allen Key screw counterclockwise. Once the screw is com-
pletely loose, remove and drop the handle down off the door handle shaft
and replace with new handle.