26
|
I1500 Regency Wood Insert
|
26
maintenance
Centre baffle
Baffle bracket
Baffle bracket
Catalyst
Note: unit in images may not be identical to the I1500—they depict the process.
The catalytic thermometer on top of the stove should read in the active zone
after the stove has been in operation for several hours. If the thermometer's
indicator needle does not stay in the active zone, even with a hot fire, over a
period of regular use, the catalyst may need to be cleaned. If this persists it
may be necessary to replace it.
If the combustor must be examined or replaced, follow this procedure:
1. Allow the stove to burn out and cool down.
2. Remove stainless steel smoke deflector - See instructions in this manual.
3. Remove the front secondary air tube with pliers as shown below.
Note: to make it easier to remove the air tubes, first remove both the bottom
right base brick and right side wall brick.
4.
Remove left and right baffle brackets (removal of left baffle bracket shown
below.
COMBUSTOR ASSEMBLY
REMOVAL / REPLACEMENT:
5
. Remove the right and left side baffles (right side baffle shown below).
6. Remove the center baffle.
8. Pull flame shield forward and tilt down, be prepared to support catalyst
assembly.
9. Loosen bolts on catalyst retainer then, slide the catalyst retainer to the
right to remove.
9. Pull down catalyst assembly to remove.
10. Reverse steps to reinstall catalyst.
7. Remove locking clip from the front face of the Catalyst assembly by slid-
ing up and out.
Содержание Cascades I1500
Страница 35: ...I1500 Regency Wood Insert 35 35 notes ...
Страница 40: ......
Страница 42: ...42 I1500 Regency Wood Insert 42 notes ...
Страница 43: ...I1500 Regency Wood Insert 43 43 ...
