Regency Fireplace Products Plateau PTO50, Инструкция для владельца и по установке

Страница: 28 / 56

28
|
Regency Plateau® PTO50 Outdoor Gas Fireplace
|
28
installation
OPTIONAL LOG SET INSTALLATION
1
OUTDOOR SERIES
919-764 03.06.17
LOG/TWIG SET INSTALLATION
Read the instructions below carefully and refer to the
images. If any of the Logs/Twigs are broken, do not use
the unit until they are replaced.
Broken Logs/Twigs can interfere with pilot operation.
Improper positioning of the Logs/Twigs may create carbon
build-up and can alter the unit's performance which is not
covered under warranty.
The PTO50 uses 2 Log/Twig Sets (#326-930), both contain
the following pieces:
Description
Log/Twig A
Log/Twig B
Log/Twig C
Log/Twig D
Log/Twig E
Log/Twig F
Diagram 3
Diagram 2
A
A
2. Install Log/Twig A on the left side of the burner, orient the Log/Twig on the left side of the burner to mirror Log A on the right—as shown in
Diagram 3.
1. Install Log/Twig A on the right side of the burner, orient the Log/Twig in the same way and in a similar location on the right side of the burner
as shown in Diagram 2.
3. Install Log/Twig D on the left side of the burner, orient Log/Twig D across Log/Twig A in the same way and in a similar position as shown in
Diagram 4.
Diagram 4
D
A
Diagram 1
F
E
D
C
B
A
Two identical log sets are installed on the right and left sides of the burner and mirror one another. After installing each Log on one side of
the burner—install the duplicate Log from the second set to mirror its mate.
NOTE:
PTO50 requires 2 log sets and when two PTO50s are assembled end to end (PTO100), 4 log sets are required.
PTO80 (PTO50 + PTO30 assembled end to end) requires 3 log sets.