Regency Fireplace Products Plateau PTO50, Инструкция для владельца и по установке

Страница: 27 / 56

Regency Plateau® PTO50 Outdoor Gas Fireplace
| 27
27
|
installation
BURNER PACKAGES
Unit Glass Crystals/Firebeads *Glass Crystals/Fir Volcanic stones ¹
PTO50 15lbs 10lbs glass/beads + 2 boxes stones- recommended
PTO80 25lbs 15lbs glass/beads + 3 boxes stones- recommended
PTO100 (2 x PTO50) 30lbs 20lbs glass /beads+ 4 boxes - recommended
NOTE:
* Glass Crystals/Firebeads are available in 5lb bags.
¹ Glass Crystals/Firebeads to be installed on the burner prior to installing stones.
Basalt Volcanic Stones are measured by weight not quantity. Each bag contains 15 lbs of stones, however the exact quantity and size vary.
Sizes vary between 2" - 3"
Evenly spread the Glass Crystals/Firebeads and optional Basalt Volcanic Stones over the burner. Ensure the crystals/beads (or stones) do not overlap too
much as this will effect the flame pattern.
IMPORTANT NOTE:
Only the supplied approved Glass Crystals/Firebeads and Basalt Volcanic stones are to be used with these fireplaces. Use of any other type of glass
crystals, beads, or stones can alter the unit's performance, any damage caused by the use of any unapproved glass or stones will not be covered under warranty.
When using Basalt Volcanic Stones DO NOT cover pilot light that lead to pilot flame.
1.
Start pouring Crystals/Firebeads on
one end of the burner.
2
. Work Crystals
/Firebeads
to other
end of the Burner. Base and burner
tube should not be visible when
crystals are spread out.
3 . Work Crystals
/Firebeads
down-
wards to front edge of top edge of
burner.
4. Basalt Volcanic Stones shown
spread evenly over the burner and
crystal base.
5.
Ensure Crystals/Firebeads do not
block the front of the pilot hood and
flame to light the burner.
NOTE:
Basalt Volcanic Stones are NOT to be placed anywhere on the Pilot assembly area.
Glass Crystals/Firebeads to be installed on the burner prior to installing stones.
NOTE:
Correct final glass installation of Crystals/Firebeads as shown in step 2 and 3.
The Burner should not be visible when the
fl
ame is out.
GLASS CRYSTAL / BASALT VOLCANIC STONES INSTALLATION