Regency Fireplace Products Plateau PTO50, Инструкция для владельца и по установке

Страница: 19 / 56

Regency Plateau® PTO50 Outdoor Gas Fireplace
| 19
19
|
installation
WALL SWITCH AND BATTERY INSTALLATION
(INCLUDED WITH UNIT)
919-776 08/15/11 1
OUTDOOR SERIES
WALL SWITCH INSTALLATION
(INCLUDED WITH UNIT)
The unit comes with low voltage wire and a battery extension wire installed.
1. Run supplied wire to desired location - to a maximum of 9 feet.
2. Install supplied electrical box in desired location.
3. Remove center knock out from electrical box and install strain relief (strain
relief nut not required).
4. Route low voltage wire and battery extension wire through the strain relief.
5. Connect low voltage wire to supplied switch, fasten switch to right side of
electrical box (polarity not important).
7. Using silicone, completely seal strain relief to protect from water or moisture.
8. Place supplied gasket on top of electrical box.
9. Fasten cover to electrical box using supplied screws.
10. Place switch in <OFF> position until fi nal installation is complete.
Center knock out
Strain Relief
6. Install supplied 4-AA batteries into the battery holder. Using velcro install
battery holder to the backside of the battery compartment door. Connect
battery terminal.