Regency Fireplace Products FG39LPG1-BRA, Инструкция для владельца и по установке

Страница: 8 / 44

8 Regency FG39-1 FireGenie Freestanding Gas Stove
LOUVER
INSTALLATION
1) Attach the top & bottom louvres to the
side stove panel using 2 screws per
side.
INSTALLATION
FLUEING
INTRODUCTION
The DV Stove Horizontal Flue Kit and the Simp -
son Dura-Flue Room Sealed System Model
DV-GS fluing systems, in combination with
the Regency Room Sealed Freestanding Gas
Stove, FG39NG1-BRA, and FG39LPG1-BRA,
have been tested and listed as direct flue heater
systems by AGA.
These units use the "balanced flue" technology
Co-Axial system. The inner liner flues products
of combustion to the outside while the outer pipe
draws outside combustion air into the combus -
tion chamber thereby eliminating the need to
use heated room air for combustion and losing
warm room air up the chimney.
Note: These flue pipes must not be con -
nected to any other appliance.
The gas appliance and flue system must be
flueed directly to the outside of the building,
and never be attached to a chimney serving a
separate solid fuel or gas burning appliance.
Each direct flue gas appliance must use it's own
separate flue system. Common flue systems
are prohibited.
IMPORTANT
Read all instructions carefully before starting the
installation. Failure to follow these instructions
may create a fire or other safety hazard, and will
void the warranty. Be sure to check the fluing
and clearance to combustible requirements.
Consult your local building codes before begin -
ning installation.
The location of the termination cap must conform
to the requirements in the Exterior Flue Termina -
tion Locations diagram on page 8.
INSTALLATION
PRECAUTIONS
These fluing systems are engineered products
that have been designed and tested for use with
the FG39NG1-BRA, and FG39LPG1-BRA. The
warranty will be voided and serious fire, health
or other safety hazards may result from any of
the following actions:
1)
Installation of any damaged Room Sealed
component
2) Unauthorized modification of the Room
Sealed System
3) Installation of any component part not manu -
factured or approved by Simpson Dura-Flue
or FPI Fireplace Products International
Ltd.
4) Installation other than as instructed by
Simpson Dura-Flue and FPI Fireplace
Products International Ltd.
Warning: Always maintain required
clearances (air spaces) to nearby
combustibles to prevent a fire
hazard. Do not fill air spaces with
insulation.
Be sure to check the flue termination clearance
requirements from decks, windows, soffits,
gas regulators, air supply inlets and public
walkways as specified in the Exterior Flue
Terminal Locations on page 8 and in your local
building codes.
The gas appliance and flue system must be
flueed directly to the outside of the building,
and never be attached to a chimney serving
a separate solid fuel or gas-burning appli-
ance. Each direct flue gas appliance must use
it's own separate flue system. Common flue
systems are prohibited.
SAFETY
PRECAUTIONS FOR
THE INSTALLER
1) Wear gloves and safety glasses for protec -
tion.
2)
Exercise extreme caution when using
ladders or on roof tops.
3) Be aware of electrical wiring locations in
walls and ceilings.