Regency Fireplace Products Classic I2453M, Инструкция для владельца и по установке

Страница: 6 / 36

6
|
Regency I2453M
|
6
installation
Clearance diagram for installations
Side and Top facing is a maximum of 1-1/2" (38mm) thick.
Note: If there is only a top facing and no side facing, refer to (B) mantle (to top of unit) clearance requirements.
Masonry And Factory Built Fireplace Clearances
The minimum required clearances to combustible materials when installed into a masonry or factory built fireplace are listed below.
*Floor Protection
Floor thermal insulation/protection with a R value of 1.4 is required if the unit is raised 0 - 2.5"
(0-64mm) (measured from the bottom of the appliance).
Thermal floor protection is not required when unit is raiser greater than 2.5" (64mm) (measured
from the bottom of the appliance).
Please check to ensure that your floor protection and hearth will meet the standards for clear-
ance to combustibles. Your hearth extension must be made from a non-combustible material.
Extending 16" for US and 18" for Canada—measured from the fuel loading door.
CLEARANCES ARE CRITICAL
** Mantel can be installed anywhere in shaded area
or higher using the above scale.
Note: Ensure the paint that is used on
the mantel and the facing is "heat
resistant" or the paint may discolour.
Unit
I2453M
Adjacent
Side Wall
(to Side)
A
Mantle **
(to Top of
Unit)
B
Top
Facing
(to Top of Unit)
C
Side
Facing
D
Minimum
Hearth
Extension*
E
Minimum
Hearth Side
Extension*
F
To Top of Unit
G
12" (305mm) 14"(356mm)
for 3-1/2" (89mm)
mantel 14" (356mm) 1/2"(13mm)
to side surround 16" (406mm) USA 8" (203mm) 20" (508mm)
18"(457mm) Canada
17"(432mm)
for 12" (305mm)
mantel
WOOD INSERT SPECIFICATIONS
Your fireplace opening requires the following minimum sizes:
Height: 21.5" (546 mm)
Width:
25" (635 mm)
Depth: 17" (432 mm)
Two faceplates are available to seal the fireplace opening:
Standard
W 40" (1 016 mm) x H 30" (762 mm)
Oversize
W 48" (1 219 mm) x H 33" (838 mm)