Regency Fireplace Products Classic I2453M, Инструкция для владельца и по установке

Страница: 11 / 36

Regency I2453M
|
11
11
|
installation
Faceplate and Trim Installation
Wood Insert
Faceplate & Trim Assembly
WOOD INSERT
I2500M
Your Faceplate kit contains:
1 Set Faceplate panel (top, left & right)
1 Set Trim (top, left, right)
2 pcs. insulation
4 spring nuts
4 1" screws
8 washers
2 screws - black
2 corner trim clips
Note: The Digital Monitor Operating Door tool Bracket
and tool holder are supplied with the insert.
Prior to sliding your insert into its final position and
attaching the connector or liner pipe, the faceplate must
be installed as follows:
1) Slide the spring nuts (supplied) over the slots in
the insert’s side convection panels (the spring nuts
may need to be squeezed with a pair of pliers first,
to help them stay in position).
2) Screw the side faceplate panels, (item A in the
diagram) one to each side. See diagram 1.
3) Using the top panel (item B - see diagram 1)
as a gauge, check that the side panels are within
approximately 1/4" of the overall width. If the
difference is greater than this, use the supplied
washers to attain the required width.
4) The unit may now be slid into final position and
attached to the connection system.
5) Once connection is made, the insulation strips
should be installed between the insert faceplates
and the fireplace face.
6) The faceplate top may now be installed (with insula-
tion strip behind) by aligning its brackets with the
top flange on the side shields and the angle iron
bar on the insert top.
7) The faceplate trim may be installed to the edge of
the faceplate at this time. To permanently mount the
trim, drill two 5/32" diameter holes through the trim
and side panels and screw the trim to the panels
using the gold plated screws provided.
Note:
It may be easier to install the insulation, faceplate
top and faceplate trim with the unit pulled slightly
away from the fireplace face. If this is done, be
very careful not to disturb the connector when
shifting the unit to its final position.
8 ) Now that your insert is installed, check once more
that all the clearances from the unit to any combus-
tible materials are correct as listed earlier.