28
|
Regency Bellavista
®
B41XTE -11 Gas Fireplace
installation
10.
From the inside of the firebox:
place the exhaust assembly into position
as shown in Diagram 1 and secure with 10 - 1/4" x 1/2" screws (Diagram
2). Ensure all screws are tight, but do not over tighten.
All 10 screws must be used.
Diagram 1
Diagram 2
12.
From the outside rear of the firebox:
install the intake cover plate with
4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not over tighten.
All 4 screws must be used.
13. Set vent restrictor accordingly - see next page.
14.
From inside the firebox:
re-install the baffle plate from step 2.
11.
From the outside top of the firebox
: install the intake collar assembly.
Secure with 4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not
over tighten. All 4 screws must be used.
Intake Collar
Assembly
Exhaust
Assembly
8.
From the outside top of the firebox:
completely remove the insulation
under the cover plate as shown and discard.
9.
From the outside back of the firebox:
locate the insulation deflector
and bend completely upwards flat against the back of firebox.
IMPORTANT:
If the insulation deflector is not bent flat against the back of
the firebox this will block air intake which will affect the unit's performance.
View Front of Firebox
Insulation Deflector
