14
c) Switching on the quadrocopter
So that the receiver in the quadrocopter can respond to the transmitter signals, the receiver and the transmitter must
have the same digital coding (pairing). For this reason, it is important that you switch the quadrocopter on as described
below.
Place the fully charged quadrocopter on a flat surface.
Slide the on/off switch (1) on the back of the quadrocopter
to the left position “ON”. The blue LEDs on the front panel
and the green LEDs on the back of the quadrocopter flash
slowly.
Set the skater mode/para mode switch (see Figure 1, no.
15) to the desired position on the transmitter.
Then switch on the transmitter with the on/off button (10).
Move the joystick for the pitch and yaw function (13) all
the way forward (light arrow in Figure 6), then all the way
back (dark arrow in Figure 6) and then back to the centre
position.
The four LEDs on the quadrocopter begin to flicker, indi
-
cating the pairing process.
After successful pairing, the blue and green LEDs on the
quadrocopter and the two red LEDs on the transmitter light
up permanently.
The quadrocopter is now ready to start.
Important!
There should be no other 2.4 GHz transmitters
in the immediate vicinity during the switch-on
process. The quadrocopter must not be moved
or turned during the switch-on process.
To switch the quadrocopter off again, slide the
on/off switch on the quadrocopter to the “OFF”
position and then switch off the transmitter.
Figure 6
Содержание 2142121
Страница 1: ...Operating Instructions Electric quadrocopter Drone Copter 2 in 1 RtF Item no 2142121 ...
Страница 35: ...35 ...