10
9. Using the transmitter
The numbers used in these instructions refer to the figure alongside the text or the figures within the re
-
spective section. For this reason, the same number represents different locations and different controls in
different images. Cross-references to other figures are indicated with the corresponding figure number.
a) Inserting the batteries
Two Micro batteries are required to supply the transmitter.
Important!
Use only batteries (1.5 V/cell) and do not use rechargeable batteries (1.2 V/cell) as the power supply for
the transmitter.
To insert the batteries, proceed as follows:
Loosen the locking screw (1) of the battery compartment
cover (2) with the included screwdriver on the transmitter
rear side.
Press the locking lever (3) down and lift the battery com-
partment cover upwards.
Insert 2 Micro/AAA batteries at the bottom of the battery
compartment (4) with the correct polarity according to the
specifications. The spiral spring contact (5) must always
be connected to the negative pole of the battery.
First replace the battery compartment cover and then let
the locking lever snap into the transmitter housing.
Then tighten the retaining screw on the battery compart-
ment cover (1) again.
Figure 2
Содержание 2142121
Страница 1: ...Operating Instructions Electric quadrocopter Drone Copter 2 in 1 RtF Item no 2142121 ...
Страница 35: ...35 ...